Gateway Computer Drive Manuel d'utilisateur télécharger pdf (Page 12)

Chapter 2: Removing an Existing Drive

www.gateway.com

Removing the drive

To remove the existing drive:

1 Turn off your computer, then remove the computer case cover following

the static electricity precautions on page 3.

See the documentation that came with your computer for instructions on

removing your computer case cover.

2 If you are removing a CD or DVD drive, disconnect the audio cable by

pressing down on the locking tab as you pull the cable out of the audio

connector. Make sure that you pull the connector, not the cable.

3 If you are removing a CD, DVD, diskette, tape, or Zip drive, disconnect

the wide, flat ribbon (data) cable from the drive that you are replacing.

Make sure that you pull the connector, not the cable. Note the orientation

of the red-striped edge of the data cable. You will attach the data cable to

your new drive using the same orientation. Go to Step 6.

- OR -

If you are removing a flash memory drive, go to the next step.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Pas de commentaire

Gateway Computer Drive Manuel d'utilisateur Page 12