Gateway 6400 Manuel d'utilisateur Page 51
- Page / 148
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
42 Replacing and Adding System Components
To remove the processor:
1 Open the locking lever on the processor socket by moving the lever
slightly out to the side and then lifting it up 90 degrees.
2 Lift the old processor straight up and out of the socket.
To install the new processor:
1 Hold the new processor over the empty processor socket and verify that
pin 1 on both the processor and the socket are aligned. Pin 1 is near the
marked corner of the processor.
2 Gently place the new processor into the socket, then secure the processor
by lowering the locking lever until the lever latches into place. The
processor will slip into place without pressure when aligned correctly.
Locking
lever
Processor
Pin 1
05032.book Page 42 Monday, July 10, 2000 11:43 AM
- 6400 Server 1
- System Manual 1
- Contents 2
- Convention Description 6
- Features 10
- Front panel 11
- Front panel 3 12
- Rear panel 13
- Rear panel 5 14
- System board 15
- System board 7 16
- 8 System Features 17
- System Setup 18
- Starting your system 19
- Starting your system 11 20
- Power button 20
- Power LED 20
- 12 System Setup 21
- Turning off your system 22
- Resetting your system 23
- Case Access 24
- 16 Case Access 25
- Opening the case 26
- Removing the side cover 27
- Removing the bezel 28
- Closing the case 29
- Replacing the side cover 30
- 22 Case Access 31
- Replacing and 32
- Adding System 32
- Components 32
- Drive cabling information 34
- Adding a 3.5-inch device 36
- Replacing or adding drives 29 38
- Adding a 5.25-inch device 39
- Hard drive 42
- Adding a hard drive 43
- Replacing or adding drives 35 44
- Replacing or adding memory 46
- To add or remove DIMMs: 47
- Replacing or adding memory 39 48
- To remove the heatsink: 49
- Metal clip 50
- To remove the processor: 51
- To install the new processor: 51
- To replace the heatsink: 52
- Adding an expansion card 54
- Replacing the battery 56
- Replacing the battery 49 58
- Replacing the system board 59
- Replacing the system board 51 60
- Standoff 60
- To install the system board: 61
- Replacing the system board 53 62
- Replacing the power supply 64
- Replacing the power supply 57 66
- Replacing the system fans 67
- Replacing the system fans 59 68
- Replacing the system fans 61 70
- Release tabs 71
- Replacing the system fans 63 72
- System fault 73
- LED resetswitch 73
- Using the BIOS 76
- Setup Utility 76
- Updating the BIOS 78
- The Clear Password switch 79
- The Clear CMOS switch 79
- Using the BIOS Setup Utility 81
- Managing Your 82
- Line conditioners 83
- Maintaining and managing your 84
- Checking hard drive space 85
- To check hard drive space: 85
- Backingupfiles 85
- To run Backup in Windows NT: 85
- Deleting unneeded files 85
- To delete .tmp files: 86
- To remove a virus: 87
- ManageX Event Manager 88
- System security 88
- 80 Managing Your System 89
- Using passwords 89
- Changing passwords 89
- Unattended start mode 90
- 82 Managing Your System 91
- System recovery 92
- 84 Managing Your System 93
- Cleaning Your 94
- Cleaning the keyboard 95
- Cleaning the monitor screen 95
- Troubleshooting 96
- Troubleshooting checklist 97
- CD drive problems 98
- 90 Troubleshooting 99
- Diskette drive problems 100
- Hard drive problems 101
- Memory and processor problems 102
- Modem problems 103
- Peripheral/adapter problems 104
- Printer problems 105
- Probable cause Solution 106
- System problems 107
- The keyboard does not work 108
- The mouse does not work 108
- Video problems 109
- The video is distorted 110
- 102 Troubleshooting 111
- Error messages 112
- 104 Troubleshooting 113
- Error message Solutions 114
- 106 Troubleshooting 115
- Safety and 116
- Regulatory 116
- Information 116
- Settingupyoursystem 117
- Care during use 117
- Warnings 119
- Warnings 111 120
- American users 122
- Declaration of Conformity 123
- Responsible Party 123
- Canadian users 124
- European users 125
- Japanese users 126
- EMI statement 127
- Laser safety statement 128
- Television antenna connectors 128
- TV/cable TV tuner cards) 128
- Reference Grounding component 129
- All rights reserved 130
- Trademark acknowledgments 130
- Reference Data 132
- Environmental specifications 133
- System I/O addresses 134
- 126 Reference Data 135
- Address Resource 136
- 128 Reference Data 137
- Memory map 138
- Interrupts 139
- Interrupt I/O APIC 140
- Description 140
- DMA usage 141
- Index 133 142
- Index 135 144
- Index 137 146
- 138 Index 147
Produits connexes et manuels pour Serveurs Gateway 6400
Serveurs Gateway ALR 9200 Manuel d'utilisateur
(226 pages)
(226 pages)
Serveurs Gateway 9415 Manuel d'utilisateur
(188 pages)
(188 pages)
Serveurs Gateway 960 Manuel d'utilisateur
(157 pages)
(157 pages)
Serveurs Gateway 955 Manuel d'utilisateur
(144 pages)
(144 pages)
Serveurs Gateway E-9520T Manuel d'utilisateur
(114 pages)
(114 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.243 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels