Gateway 6400 Manuel d'utilisateur Page 57

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 148
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 56
48 Replacing and Adding System Components
4 Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
5 Locate the battery on the system board (see “System board” on page 6).
The battery is circular and has the positive pole mark (+) on the top.
6 Using a small, flat-bladed screwdriver, carefully remove the battery from
its socket on the system board.
7 Press the new battery in the socket with the positive pole up. Be sure you
have pressed the battery down far enough for it to contact the base of
the socket (it should snap into place).
8 Close the case by following the instructions on page 20.
9 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
10 If the CMOS data is not correct, change the information in the BIOS Setup
utility using the data you recorded in Step 2.
Troubleshooting the battery installation
If you have problems after installing the new battery, try each of the items
listed below:
Turn off the computer and make sure that all exterior cables are attached
and secured to the correct connectors.
Make sure that all power switches are on. If the computer is plugged into
a power strip or surge protector, make sure it is turned on also.
Enter the BIOS Setup utility and compare the settings on the screen with
your notes or the system hardware manuals. Correct any discrepancies.
05032.book Page 48 Monday, July 10, 2000 11:43 AM
Vue de la page 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 147 148

Commentaires sur ces manuels

Pas de commentaire